MCD Instructions

Lots of images, this page may take a while to load.

Developed by ClubFem

Texas' first exclusive Female Domination Group

Instructions & Tips

The Original Male Chastity Device

Congratulations on obtaining the Club Fem Phallic chastity device

Please follow the directions in this pamphlet for easier fitting and use on the phallus. The following items will be needed to fasten the MCD on the phallus:

Sharp Scissors
File (standard fingernail file works fine)
Indelible Marker with sharp point
Glue (super glue – Gelled is best)

TIPS FOR USING THE MCD

A) For long-term use on the phallus, be sure to change position frequently. Pull phallus out phallus to reduce diameter and gently nudge MCD higher or lower, depending on original location of MCD

B) Spikes may be filed down to slightly reduce points. Try the MCD first without filing and only file if needed (tests have indicated that filing is often needed.)

C ) be sure channel is on bottom side of MCD to prevent too much pressure on bottom of phallus (urethral channel)

D ) When first using the MCD use standard electrical tie wraps, not the special wraps included in this package. The standard tie wraps are easily obtained from a hardware and are quite inexpensive. Take a tie wrap with you so you know what size to get from the store.

E ) Cleanliness is very easy with the MCD because all the channels and openings allow water to flow-through for cleaning and air for drying topass through easily.

1) The MCD comes with its own set of tie-wraps.

2) The Mistress uses an indelible marker to sign Her name and put the date on the tie wrap tab.

3) Determine a good fit by putting the MCD around a soft phallus.

4) Fit MCD snugly around phallus and mark the device where the edges meet

5) Put tie-wrap through slot in top of MCD. Make sure name is facing out. Put tie-wrap through the slot with no spikes .

6) Put tie-wrap through bottom side of spiked MCD. Make sure mark lines up for size to be correct.

7) Match mark by putting bottom side over top of spiked side. Slide over phallus opening MCD up as wide as needed

8) When MCD is on pull tie-wrap through to tighten up. Pull slowly to prevent pinching

9) This is what the MCD should look like. Note the urinal channel is on the bottom side

10) Pull tie-wrap through the locking side to secure in place. Test to be sure the name tab fits flush with the top of the MCD before locking

11) Cut loose end of tie-wrap flush with locking end.

12) Use file (metal is best) to file rough end of tie-wrap

13) Put a drop of superglue (gelled is best so it wont run) in locking top of tie-wrap.

This will help make a smooth top and also prevent unlocking with a sharp point.

14) Completed MCD. Note signed name tab fits snugly on top side of MCD

15) After a test period. If spikes are too uncomfortable, file down with fingermail

16) If MCD is too large in diameter at smallest setting. Some can be cut off one row at a time on the spiked side only. Do not cut smooth side to adjust length or MCD will not fit properly.